|
|
Installation of the railing then began. Here, Scott attaches a baluster to the rail. |
|
The railing was reinforced at regular intervals with 4x4 posts, as seen here. |
|
|
|
Pressure treated 2x4's were then installed as railing caps. |
|
Here, Scott finishes putting screws into the pre-drilled holes on the ends of the decking boards. |
|
|
|
The ends of the support beam were trimmed and a 45-degree cut was made for decorative effect. |
|
The outdoor lamp was then replaced with a brass lamp with a built-in motion sensor. The old lamp is shown on the right. |
|
